Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0
Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0 image 1
Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0 image 2
Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0 image 3
Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0 image 4

Raspberry Pi Zero Camera Module 5MP Webcam Support 1080p30 720p60 And 640x480 Video Record Support Raspberry Pi Zero V3.0

US $16

Product Specification

  • Sensor type:  OV5647 

 

  • Resolution:2592 x 1944

 

  • FOV: 72 degrees

 

  • Object distace: 5cm to infinity

 

  • Video frame rate: 1080p at 30 fps with codec H.264 (AVC)  Up to 90 fps Video at VGA

 

  • FPC Length:60mm * 300mm*11.5mm*5mm

 

 

Use case

 

zero-1_

Package Included:

1 X Raspberry Pi Zero Camera Module

Note:(Raspberry pi zero is not included)

 

zero-2

 

 

Using steps:
1.Please ensure the raspberry Pi system is the newer version, and open the camera function.Type the command: sudo raspi - config and check the camera function of the fifth.The picture below:
 
HTB1oKayNFXXXXbNXVXXq6xXFXXXK
 
2. Then select: Enable
HTB1sJ5wNFXXXXcpXVXXq6xXFXXXq
 
3. Then the system return to the interface itself. Choose the “Finish “ , it will restart:
HTB1oKayNFXXXXbNXVXXq6xXFXXXK
 

4. After the raspberry pi system restart , you can use raspberry pi camera now.

If you want to take photo, you can run the command : raspistill

For example,input: raspistill –t 2000  -o 1.jpg
-t: ( the time of waiting to take the photo ,5000 is five seconds). – o 1.jpg (1.jpg is command of file)

Tip:

Hardware connection:
1. Soft cable, 90-degree vertical connector, HDMI port next to it. When connecting the contact side facing the HDMI interface.
2. Remove the protective film before using the lens
3. bare boards, pay attention to ESD damage, guard against static electricity!
 

 

 

Reviews

2020-05-06 10:15:00